osd-contiki/examples/cc2530dk/border-router
George Oikonomou 2f89f41b5a cc2x3x RPL/non-RPL handling:
- Relevant examples explicitly request it in their Makefile
- Removed the definition of UIP_CONF_IPV6_RPL from
  contiki-conf.h. If needed, it's defined through a -D
2012-05-16 15:22:31 +01:00
..
border-router.c New platform: TI cc2530 Development Kit 2012-03-23 14:41:07 +00:00
Makefile cc2x3x RPL/non-RPL handling: 2012-05-16 15:22:31 +01:00
Makefile.target New platform: TI cc2530 Development Kit 2012-03-23 14:41:07 +00:00
project-conf.h New platform: TI cc2530 Development Kit 2012-03-23 14:41:07 +00:00
README New platform: TI cc2530 Development Kit 2012-03-23 14:41:07 +00:00
slip-bridge.c New platform: TI cc2530 Development Kit 2012-03-23 14:41:07 +00:00

border-router example for the TI SmartRF05EB with a cc2530EM.

This example is meant to be used with tunslip6 in tools/

- Build the code and load it onto your node
- Connect your node to your PC
- run:
  sudo ./tunslip6 -s /dev/ttyUSBx <address v6>/<prefix>
  
  This will setup tun0 on your PC over device /dev/ttyUSBx. The address
  argument should contain the v6 address that you want to assign to tun0
  The node will use this address to obtain the network prefix
  
  for example:
  sudo ./tunslip6 aaaa::1/64
  This will use aaaa:: / 64 as the prefix for the 15.4 network.