Due to errors in mspsim and/or radio drivers, packets of incorrect
length are sometimes transmitted. The length might be larger than
the 127-byte maximum (considered negative in the current code)
or not matching the actual number of transmitted bytes.
This leads to wrong packet delimiting when converting from
the mspsim-level stream of bytes to Cooja-level packets
causing unhandled exceptions that terminate the simulation.
This patch checks the frame preamble (0000007A) and the length field.
If they are wrong, no decoding attempt is done.
The transmitted bytes are still delivered to the receivers untouched.
The connection is terminated when the radio state is changed (which alway
s happens when TX is done).
Nowadays many HTTP server set cookies which may easily result in HTTP header fields longer than our 'httpheaderline' buffer. It doesn't hurt if we can't parse them but we need to be able to skip them and continue to parse the following header fields.
WWW_CONF_MAX_URLLEN is used as length for the 'editurl' textentry widget. The CTK code for handling that widget uses a single byte so the length can't be > 255. Thus WWW_CONF_MAX_URLLEN can't be > 255 as well.
* Fix CCA detection in Cooja in the case when the receiver swicthes on the right channel during an ongoing transmission. Always add a connection on transmission, even when the channel is not correct. Initially the connection is in a dormant state; this mimics what Cooja is doing when the receiver radio is turned off;
when the receiver is turned on and switched to the right channel, `updateSignalStrengths()` is called, and the connection starts to recieve PHY-level traffic.
* Add "channel" property for DGRM edges.
* Avoid cross-channel interference on DGRM and MRM radio mediums
Only the interrupt flags that have been handled must be cleared.
Otherwise, if a new interrupt occurs after the interrupt statuses are
read and before they are cleared, then it is discarded without having
been handled. This issue was particularly likely with two interrupt
trigger conditions occurring on different pins of the same port in a
short period of time.
Signed-off-by: Benoît Thébaudeau <benoit.thebaudeau.dev@gmail.com>
Power-up interrupts do not always update the regular interrupt status.
Because of that, in order not to miss power-up interrupts, the ISR must
handle both the regular and the power-up interrupt statuses.
Signed-off-by: Benoît Thébaudeau <benoit.thebaudeau.dev@gmail.com>
Introduce new useful GPIO macros to:
- get the raw interrupt status of a port,
- get the masked interrupt status of a port,
- get the power-up interrupt status of a port.
These macros are cleaner and less error-prone than raw register access
code copied all over the place.
Signed-off-by: Benoît Thébaudeau <benoit.thebaudeau.dev@gmail.com>
