deac/osd-contiki
1
0
Fork 0
Code Issues Pull requests Releases Wiki Activity
3741 commits 6 branches 13 tags 80 MiB
Commit graph

961 commits

Author SHA1 Message Date
nvt-se
74e9bc8789 Added flash reads and writes to energest. 2009-05-11 15:26:24 +00:00
adamdunkels
900480959b Increased the default number of queue buffers: there usually is plenty of RAM left, so we should be able to afford it 2009-05-10 21:15:16 +00:00
joxe
6a7bc4c3a5 added mcu-chip temperature to accelerometer sensor - value 3 2009-05-08 16:03:50 +00:00
adamdunkels
6fcca2d545 Initialize ctimer, add IPv6 address configuration for the aaaa prefix 2009-04-29 11:49:27 +00:00
adamdunkels
e6215712ca When a node is configured as an IP gateway, we switch off the power-saving MAC protocolto improve performance and to avoid problems with the serial communication that X-MACs use of rtimers can cause 2009-04-29 11:46:20 +00:00
adamdunkels
064f4488d4 Increase default CPU speed from 2.4576 MHz to 3.9 MHz. Communication works better, at a low power cost 2009-04-29 11:43:48 +00:00
adamdunkels
bbab7ba55c When the tmote-bsl binary is found, program only one mote at once (parallel programming with tmote-bsl doesn't seem to work) 2009-04-29 11:42:56 +00:00
fros4943
9f299c277e added experimental slip support for contiki motes 2009-04-23 09:15:51 +00:00
fros4943
9bd3d07510 implemented slip_arch_writeb() function 2009-04-23 09:02:06 +00:00
fros4943
b65014d1be bugfix by Wolf-Bastian Pöttner: check buffer size at incoming radio data 2009-04-16 14:38:41 +00:00
fros4943
bc6704079c cc2420 checksums temporarily disabled, due to timing problems with the x-mac unicast optimization 2009-04-16 14:34:51 +00:00
adamdunkels
2e37fca49f Check for tmote-bsl-linux binary under linux, and use it is available 2009-04-10 07:43:29 +00:00
adamdunkels
2545fd9069 Hack to make DS2411 ID useable as an Ethernet MAC address (remove multicast bit) 2009-04-10 00:40:08 +00:00
adamdunkels
3415ff26bd Added CC2420 checksums to non-ipv6 packets. Set a conservative TCP MSS 2009-04-10 00:39:19 +00:00
nvt-se
172ffb74c7 fix compiler warnings. patch from Jesper Karlsson. 2009-04-08 14:56:00 +00:00
nifi
b41b79e3a9 Disable timestamp when using 802.15.4 frames (CC2420_CONF_TIMESTAMPS adds timestamp to radio packets). 2009-04-06 17:18:20 +00:00
nifi
900d8d8e17 changed to use HC01 compression for uip6 2009-04-06 16:01:11 +00:00
nifi
8b41f3a6a8 set rime addr size to 8 for uip6, restored clock resolution 2009-04-06 14:59:49 +00:00
nifi
76b7bf43d0 added setup for uip6 with 802.15.4 frames and routing using Rime 2009-04-06 14:12:58 +00:00
nifi
a36e529df1 added configuration for panid 2009-04-06 13:31:00 +00:00
nvt-se
f53560f6a5 enabled multihop routing, increased uip buffer size. 2009-04-06 13:23:14 +00:00
nifi
c1d490b6a7 added workaround for memcpy/memset bug in mspgcc 2009-04-06 13:07:37 +00:00
adamdunkels
58331e6802 Made tick resultion more fine-grained to support a shorter LPP listen time 2009-04-03 11:46:48 +00:00
fros4943
b730fb329d changed upload rules due to problems on linux platforms 2009-04-02 11:15:30 +00:00
fros4943
3b3580e439 disabled writing IP addresses from inside COOJA, since the these should rather be determined by Contiki 2009-04-01 18:11:48 +00:00
fros4943
aa736322e1 removed unused uip/uaodv cooja comm stack. mesh-uip should be used instead 2009-04-01 17:17:55 +00:00
fros4943
3665422d8d simplified cooja communication stacks initialization + added uipv6 stack 2009-04-01 13:50:12 +00:00
fros4943
6a99a82516 copied uipv6 configuration from native platform 2009-04-01 13:46:56 +00:00
fros4943
1c031504e5 no need to initialize serial line 2009-04-01 13:46:16 +00:00
fros4943
892bfb5678 moved radio-uip link functionality directly to comm stack sources 2009-04-01 13:45:41 +00:00
fros4943
eddd8350c5 renamed radio driver 2009-04-01 13:44:34 +00:00
fros4943
afed9bb2d0 icnlude packet radio by default 2009-04-01 13:39:54 +00:00
nifi
c6b15c289e * show radio channel at startup 
* only initialize timesynch when timesynch is enabled
 2009-03-31 13:25:50 +00:00
nvt-se
e90149b7b4 avoid switching mode when tx or rx is active. 
based on suggestions from Frederik Hermans and some code from Jesper Karlsson.
 2009-03-30 14:07:34 +00:00
fros4943
5f1fda0406 removed unused variables + writing serial data in timeevent 2009-03-26 16:23:47 +00:00
fros4943
dda6de8438 + clock stub functions 2009-03-26 16:22:36 +00:00
fros4943
ac22ad5081 changed the Makefile rules for uploading to sky-nodes. 
the earlier approach caused problems sometimes, resulting in command succeeding without all nodes being reprogrammed
 2009-03-26 13:29:44 +00:00
nvt-se
04bd414e1c enabled LPP by default. 2009-03-26 12:51:55 +00:00
nvt-se
90b9b9bae3 configure LPP parameters with slightly longer listen time since the CC1020 
driver switches from TX mode to RX mode rather slowly.

decreased CCA check timeout.
 2009-03-26 12:47:12 +00:00
nvt-se
25cc327acc avoid hanging in TX mode after CCA check failed. 
minor memory savings.
 2009-03-25 15:25:05 +00:00
nvt-se
96fbf3b853 use old style C comments. 
convert printf to PRINTF.
remove unnecessary MS_DELAY calls from setupTX and setupRX.
 2009-03-24 15:32:26 +00:00
nvt-se
15c447e57e remove some unnecessary instructions and function calls. patch from Jesper Karlsson. 2009-03-24 15:13:11 +00:00
nvt-se
143c7f9cea switched from serial to serial_line. patch from Jesper Karlsson. 2009-03-24 15:02:03 +00:00
fros4943
c76f34ff98 minor serial test application update 2009-03-21 15:47:40 +00:00
fros4943
9c9165dc90 start cooja with more memory to avoid outofmemory problems when running mspsim-based simulations 2009-03-20 13:23:44 +00:00
nvt-se
6b22fa60e8 - avoid costly rx state initialization if the radio is already on. 
- code formatting.
 2009-03-19 14:43:31 +00:00
nvt-se
8f85355f02 print the MAC protocol name when starting the node 2009-03-19 14:14:06 +00:00
nvt-se
b9ef907690 enable serial line tools using the same commands as the sky platform's Makefile 2009-03-17 22:27:14 +00:00
nvt-se
7e329ab467 removed obsolete file. 2009-03-17 22:20:04 +00:00
adamdunkels
b1cd9c207a Removed serial.c, which is obsoleted by serial-line.c, which in turn now resides in Makefile.include 2009-03-17 21:51:13 +00:00