abeed93da5
This patch adds a simple, space-efficient driver for the Ethernet interface built into the Intel Quark X1000. It only allocates a single packet descriptor for each of the transmit and receive directions, computes checksums on the CPU, and enables store-and-forward mode for both transmit and receive directions.
243 lines
7.5 KiB
C
243 lines
7.5 KiB
C
/*
|
|
* Copyright (C) 2015, Intel Corporation. All rights reserved.
|
|
*
|
|
* Redistribution and use in source and binary forms, with or without
|
|
* modification, are permitted provided that the following conditions
|
|
* are met:
|
|
* 1. Redistributions of source code must retain the above copyright
|
|
* notice, this list of conditions and the following disclaimer.
|
|
* 2. Redistributions in binary form must reproduce the above copyright
|
|
* notice, this list of conditions and the following disclaimer in the
|
|
* documentation and/or other materials provided with the distribution.
|
|
*
|
|
* 3. Neither the name of the copyright holder nor the names of its
|
|
* contributors may be used to endorse or promote products derived
|
|
* from this software without specific prior written permission.
|
|
*
|
|
* THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS
|
|
* ``AS IS'' AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT
|
|
* LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS
|
|
* FOR A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE
|
|
* COPYRIGHT HOLDER OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT,
|
|
* INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES
|
|
* (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR
|
|
* SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION)
|
|
* HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT,
|
|
* STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE)
|
|
* ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED
|
|
* OF THE POSSIBILITY OF SUCH DAMAGE.
|
|
*/
|
|
|
|
#include <assert.h>
|
|
|
|
#include "pci.h"
|
|
#include "helpers.h"
|
|
|
|
/* I/O port for PCI configuration address */
|
|
#define PCI_CONFIG_ADDR_PORT 0xCF8
|
|
/* I/O port for PCI configuration data */
|
|
#define PCI_CONFIG_DATA_PORT 0xCFC
|
|
|
|
/*---------------------------------------------------------------------------*/
|
|
/* Initialize PCI configuration register address in preparation for accessing
|
|
* the specified register.
|
|
*/
|
|
static void
|
|
set_addr(pci_config_addr_t addr)
|
|
{
|
|
addr.en_mapping = 1;
|
|
|
|
outl(PCI_CONFIG_ADDR_PORT, addr.raw);
|
|
}
|
|
/*---------------------------------------------------------------------------*/
|
|
/**
|
|
* \brief Read from the specified PCI configuration register.
|
|
* \param addr Address of PCI configuration register.
|
|
* \return Value read from PCI configuration register.
|
|
*/
|
|
uint32_t
|
|
pci_config_read(pci_config_addr_t addr)
|
|
{
|
|
set_addr(addr);
|
|
|
|
return inl(PCI_CONFIG_DATA_PORT);
|
|
}
|
|
/*---------------------------------------------------------------------------*/
|
|
/**
|
|
* \brief Write to the PCI configuration data port.
|
|
* \param addr Address of PCI configuration register.
|
|
* \param data Value to write.
|
|
*/
|
|
void
|
|
pci_config_write(pci_config_addr_t addr, uint32_t data)
|
|
{
|
|
set_addr(addr);
|
|
|
|
outl(PCI_CONFIG_DATA_PORT, data);
|
|
}
|
|
/*---------------------------------------------------------------------------*/
|
|
/**
|
|
* \brief Enable PCI command bits of the specified PCI configuration
|
|
* register.
|
|
* \param addr Address of PCI configuration register.
|
|
* \param flags Flags used to enable PCI command bits.
|
|
*/
|
|
void
|
|
pci_command_enable(pci_config_addr_t addr, uint32_t flags)
|
|
{
|
|
uint32_t data;
|
|
|
|
addr.reg_off = 0x04; /* PCI COMMAND_REGISTER */
|
|
|
|
data = pci_config_read(addr);
|
|
pci_config_write(addr, data | flags);
|
|
}
|
|
/*---------------------------------------------------------------------------*/
|
|
/**
|
|
* \brief Set current PIRQ to interrupt queue agent. PCI based interrupts
|
|
* PIRQ[A:H] are then available for consumption by either the 8259
|
|
* PICs or the IO-APIC depending on configuration of the 8 PIRQx
|
|
* Routing Control Registers PIRQ[A:H]. See also pci_pirq_set_irq().
|
|
* \param agent Interrupt Queue Agent to be used, IRQAGENT[0:3].
|
|
* \param pin Interrupt Pin Route to be used, INT[A:D].
|
|
* \param pirq PIRQ to be used, PIRQ[A:H].
|
|
* \return Returns 0 on success and a negative number otherwise.
|
|
*/
|
|
int
|
|
pci_irq_agent_set_pirq(IRQAGENT agent, INTR_PIN pin, PIRQ pirq)
|
|
{
|
|
pci_config_addr_t pci;
|
|
uint16_t value;
|
|
uint32_t rcba_addr, offset = 0;
|
|
|
|
assert(agent >= IRQAGENT0 && agent <= IRQAGENT3);
|
|
assert(pin >= INTA && pin <= INTD);
|
|
assert(pirq >= PIRQA && pirq <= PIRQH);
|
|
|
|
pci.raw = 0;
|
|
pci.bus = 0;
|
|
pci.dev = 31;
|
|
pci.func = 0;
|
|
pci.reg_off = 0xF0; /* Root Complex Base Address Register */
|
|
|
|
/* masked to clear non-address bits. */
|
|
rcba_addr = pci_config_read(pci) & ~0x3FFF;
|
|
|
|
switch(agent) {
|
|
case IRQAGENT0:
|
|
if (pin != INTA)
|
|
return -1;
|
|
offset = 0x3140;
|
|
break;
|
|
case IRQAGENT1:
|
|
offset = 0x3142;
|
|
break;
|
|
case IRQAGENT2:
|
|
if (pin != INTA)
|
|
return -1;
|
|
offset = 0x3144;
|
|
break;
|
|
case IRQAGENT3:
|
|
offset = 0x3146;
|
|
}
|
|
|
|
value = *(uint16_t*)(rcba_addr + offset);
|
|
|
|
/* clear interrupt pin route and set corresponding pirq. */
|
|
switch(pin) {
|
|
case INTA:
|
|
value &= ~0xF;
|
|
value |= pirq;
|
|
break;
|
|
case INTB:
|
|
value &= ~0xF0;
|
|
value |= (pirq << 4);
|
|
break;
|
|
case INTC:
|
|
value &= ~0xF00;
|
|
value |= (pirq << 8);
|
|
break;
|
|
case INTD:
|
|
value &= ~0xF000;
|
|
value |= (pirq << 12);
|
|
}
|
|
|
|
*(uint16_t*)(rcba_addr + offset) = value;
|
|
|
|
return 0;
|
|
}
|
|
/*---------------------------------------------------------------------------*/
|
|
/**
|
|
* \brief Set current IRQ to PIRQ. The interrupt router can be
|
|
* programmed to allow PIRQ[A:H] to be routed internally
|
|
* to the 8259 as ISA compatible interrupts. See also
|
|
* pci_irq_agent_set_pirq().
|
|
* \param pirq PIRQ to be used, PIRQ[A:H].
|
|
* \param pin IRQ to be used, IRQ[0:15].
|
|
* \param route_to_legacy Whether or not the interrupt should be routed to PIC 8259.
|
|
*/
|
|
void
|
|
pci_pirq_set_irq(PIRQ pirq, uint8_t irq, uint8_t route_to_legacy)
|
|
{
|
|
pci_config_addr_t pci;
|
|
uint32_t value;
|
|
|
|
assert(pirq >= PIRQA && pirq <= PIRQH);
|
|
assert(irq >= 0 && irq <= 0xF);
|
|
assert(route_to_legacy == 0 || route_to_legacy == 1);
|
|
|
|
pci.raw = 0;
|
|
pci.bus = 0;
|
|
pci.dev = 31;
|
|
pci.func = 0;
|
|
pci.reg_off = (pirq <= PIRQD) ? 0x60 : 0x64; /* PABCDRC and PEFGHRC Registers */
|
|
|
|
value = pci_config_read(pci);
|
|
|
|
switch(pirq) {
|
|
case PIRQA:
|
|
case PIRQE:
|
|
value &= ~0x8F;
|
|
value |= irq;
|
|
value |= (!route_to_legacy << 7);
|
|
break;
|
|
case PIRQB:
|
|
case PIRQF:
|
|
value &= ~0x8F00;
|
|
value |= (irq << 8);
|
|
value |= (!route_to_legacy << 15);
|
|
break;
|
|
case PIRQC:
|
|
case PIRQG:
|
|
value &= ~0x8F0000;
|
|
value |= (irq << 16);
|
|
value |= (!route_to_legacy << 23);
|
|
break;
|
|
case PIRQD:
|
|
case PIRQH:
|
|
value &= ~0x8F000000;
|
|
value |= (irq << 24);
|
|
value |= (!route_to_legacy << 31);
|
|
}
|
|
|
|
set_addr(pci);
|
|
outl(PCI_CONFIG_DATA_PORT, value);
|
|
}
|
|
/*---------------------------------------------------------------------------*/
|
|
/**
|
|
* \brief Initialize a structure for a PCI device driver that performs
|
|
* MMIO to address range 0. Assumes that device has already
|
|
* been configured with an MMIO address range 0, e.g. by
|
|
* firmware.
|
|
* \param c_this Structure that will be initialized to represent the driver.
|
|
* \param pci_addr PCI base address of device.
|
|
* \param meta Base address of optional driver-defined metadata.
|
|
*/
|
|
void
|
|
pci_init(pci_driver_t *c_this, pci_config_addr_t pci_addr, uintptr_t meta)
|
|
{
|
|
/* The BAR value is masked to clear non-address bits. */
|
|
c_this->mmio = pci_config_read(pci_addr) & ~0xFFF;
|
|
c_this->meta = meta;
|
|
}
|
|
/*---------------------------------------------------------------------------*/
|