7f48057b9e
The leds API did not work in some cases. E.g. with the following sequence: leds_off(LEDS_ALL); leds_toggle(LEDS_GREEN); leds_off(LEDS_ALL); the green LED was remaining on after the last call. This was caused by the toggle feature made synonymous with the invert feature, although it is unrelated. leds_toggle() is indeed supposed to toggle an LED, while leds_invert() is supposed to change the active level of an LED. However, all users of leds_invert() actually meant leds_toggle(), and the invert feature does not make sense in this module because it is not handy due to successive calls to leds_invert() changing the intended behavior, and hardware active levels should be managed in leds_arch_set() (e.g. by XORing the passed value with a hardware-specific constant before setting the output levels of the pins). Consequently, this change: - removes the leds_invert() function, - makes leds_toggle() behave as expected relatively to leds_off() / leds_on(), - sanitizes the code in the leds module. Signed-off-by: Benoît Thébaudeau <benoit.thebaudeau@advansee.com> |
||
|---|---|---|
| .. | ||
| dev | ||
| bridge-conf.h | ||
| fakeuip.c | ||
| Makefile | ||
| README.md | ||
| sicslow_ethernet.c | ||
| sicslow_ethernet.h | ||
| uip6-bridge-tap.c | ||
See siscslow_ethernet.c for information about translation between 802.15.4 and 802.3 addresses. Devices must have a proper EUI-64 address for this bridge to work. If the EUI-64 address of the devices cannot be changed and they are incompatible with the translation mechanism, you have to change the translation rules (they are defined in mac_createSicslowpanLongAddr() and mac_createEthernetAddr()).
Usage example:
run tapslip6 (source file are located in tools folder).
./tapslip6 -p 2001:db8:bbbb:abce::/64
where 2001:db8:bbbb:abce:: is the network address and 64 is the the prefix length. The remaining 64 bits will be derived from the EUI-64 (two middle bytes will be removed).
You can also simply create an edge router in one of the network nodes: you have to enable routing and set the appropriate forwarding rules, as shown in contiki-init-net.c. Then you have to add the corresponding rule on your machine, for example:
route -A inet6 add 2001:db8:bbbb:abcd::/64 gw 2001:db8:bbbb:abce:280:e102::8a.
where 2001:db8:bbbb:abce:280:e102::6c is the address of the edge node and 2001:db8:bbbb🔡:/64 is the lowpan address.