osd-contiki/tests/rftest-rx.c

161 lines
2.9 KiB
C

#include <mc1322x.h>
#include <board.h>
#include <stdio.h>
#include "tests.h"
#include "config.h"
#define DELAY 400000
#define DATA 0x00401000;
uint32_t ackBox[10];
#define MAX_PAYLOAD 128
volatile uint8_t data[MAX_PAYLOAD];
/* maca_rxlen is very important */
#define command_xcvr_rx() \
do { \
maca_txlen = ((0xff)<<16); \
maca_dmatx = (uint32_t)&ackBox; \
maca_dmarx = (uint32_t)data; \
maca_tmren = (maca_cpl_clk | maca_soft_clk); \
maca_control = (control_prm | control_asap | control_seq_rx); \
}while(0)
#define LED LED_GREEN
#define led_on() do { led = 1; *GPIO_DATA0 = LED; } while(0);
#define led_off() do { led = 0; *GPIO_DATA0 = 0x00000000; } while(0);
volatile uint8_t led;
void toggle_led(void) {
if(0 == led) {
led_on();
led = 1;
} else {
led_off();
}
}
void main(void) {
volatile uint32_t i;
uint16_t status;
*GPIO_PAD_DIR0 = LED;
led_on();
uart_init(INC,MOD);
reset_maca();
radio_init();
flyback_init();
vreg_init();
init_phy();
/* trim the reference osc. to 24MHz */
pack_XTAL_CNTL(CTUNE_4PF, CTUNE, FTUNE, IBIAS);
set_power(0x0f); /* 0dbm */
set_channel(0); /* channel 11 */
*MACA_CONTROL = (1 << PRM) | (NO_CCA << MODE);
for(i=0; i<DELAY; i++) { continue; }
*MACA_DMARX = (uint32_t)data; /* put data somewhere */
*MACA_PREAMBLE = 0;
command_xcvr_rx();
while(1) {
if(_is_action_complete_interrupt(maca_irq)) {
maca_clrirq = maca_irq;
status = *MACA_STATUS & 0x0000ffff;
switch(status)
{
case(cc_aborted):
{
printf("aborted\n\r");
ResumeMACASync();
break;
}
case(cc_not_completed):
{
printf("not completed\n\r");
ResumeMACASync();
break;
}
case(cc_timeout):
{
printf("timeout\n\r");
ResumeMACASync();
break;
}
case(cc_no_ack):
{
printf("no ack\n\r");
ResumeMACASync();
break;
}
case(cc_ext_timeout):
{
printf("ext timeout\n\r");
ResumeMACASync();
break;
}
case(cc_ext_pnd_timeout):
{
printf("ext pnd timeout\n\r");
ResumeMACASync();
break;
}
case(cc_success):
{
// printf("success\n\r");
printf("rftest-rx --- maca_getrxlvl: 0x%02x timestamp: 0x%08x\n\r", maca_getrxlvl, maca_timestamp);
printf(" data: 0x%08x ", (uint32_t)data);
for(i=0; i<=(*MACA_GETRXLVL-4); i++) { /* fcs+somethingelse is not transferred by DMA */
printf("%02x ", data[i]);
}
printf("\n\r");
toggle_led();
ResumeMACASync();
command_xcvr_rx();
break;
}
default:
{
printf("status: %04x\n\r",status);
ResumeMACASync();
command_xcvr_rx();
}
}
} else if (_is_filter_failed_interrupt(maca_irq)) {
printf("filter failed\n\r");
ResumeMACASync();
command_xcvr_rx();
} else if (_is_checksum_failed_interrupt(maca_irq)) {
printf("crc failed\n\r");
ResumeMACASync();
command_xcvr_rx();
}
};
}