osd-contiki/tests/tests.c
2010-02-26 14:21:46 -05:00

33 lines
1 KiB
C

#include <mc1322x.h>
#include "put.h"
void uart1_init(uint16_t inc, uint16_t mod) {
/* Restore UART regs. to default */
/* in case there is still bootloader state leftover */
*UART1_CON = 0x0000c800; /* mask interrupts, 16 bit sample --- helps explain the baud rate */
/* INC = 767; MOD = 9999 works: 115200 @ 24 MHz 16 bit sample */
*UART1_BR = (inc << 16) | mod;
/* see Section 11.5.1.2 Alternate Modes */
/* you must enable the peripheral first BEFORE setting the function in GPIO_FUNC_SEL */
/* From the datasheet: "The peripheral function will control operation of the pad IF */
/* THE PERIPHERAL IS ENABLED. */
*UART1_CON = 0x00000003; /* enable receive and transmit */
*GPIO_FUNC_SEL0 = ( (0x01 << (14*2)) | (0x01 << (15*2)) ); /* set GPIO15-14 to UART (UART1 TX and RX)*/
}
void print_welcome(char* testname) {
puts("mc1322x-test: ");
puts(testname);
puts("\n\r");
puts("board: ");
#if (BOARD == redbee-dev)
puts("redbee-dev");
#elif (BOARD == redbee-r1)
puts("redbee-dev");
#endif
puts("\n\r");
}