CONTIKI_TARGET_DIRS = . apps net loader dev CONTIKI_CORE=contiki-main CONTIKI_TARGET_MAIN = ${CONTIKI_CORE}.o CONTIKI_TARGET_SOURCEFILES += contiki-main.c params.c battery-sensor.c i2c.c CONTIKI_TARGET_SOURCEFILES += sensors.c button-sensor.c slip_uart0.c slip.c leds.c temp_mcu-sensor.c light-sensor.c adc.c cfs-eeprom.c eeprom.c pulse-sensor.c CONTIKI_TARGET_SOURCEFILES += temp-sensor.c CONTIKI_TARGET_SOURCEFILES += enc28j60_avr.c CONTIKI_TARGET_SOURCEFILES += co2_sa_kxx-sensor.c CONTIKIAVR=$(CONTIKI)/cpu/avr CONTIKIBOARD=. ifdef $(MCU) MCU=$(MCU) else MCU=atmega256rfr2 endif ifeq ($(MCU),atmega128rfa1) CONTIKI_PLAT_DEFS = -DF_CPU=8000000UL -DAUTO_CRC_PADDING=2 BOOTLOADER_START = 0x1E000 endif ifeq ($(MCU),atmega128rfr2) CONTIKI_PLAT_DEFS = -DF_CPU=8000000UL -DAUTO_CRC_PADDING=2 BOOTLOADER_START = 0x1E000 endif ifeq ($(MCU),atmega256rfr2) CONTIKI_PLAT_DEFS = -DF_CPU=16000000UL -DAUTO_CRC_PADDING=2 BOOTLOADER_START = 0x3E000 endif AVRDUDE_PROGRAMMER=jtag2 # For usb devices, you may either use PORT=usb, or (e.g. if you have more than one # programmer connected) you can use the following trick to find out the serial number: # # The example is for an JTAGICE mkII used to program an ATmega128: # avrdude -v -P usb:xxxx -c jtag2 -p atmega128 AVRDUDE_PORT=usb:00B000000D79 # Additional avrdude options # Verify off AVRDUDE_OPTIONS=-V AVRDUDE_MCU=m256rfr2 include $(CONTIKIAVR)/Makefile.avr include $(CONTIKIAVR)/radio/Makefile.radio #MODULES += core/net/mac core/net core/net/mac/sicslowmac core/net/mac/contikimac core/net/llsec core/net/rime MODULES += core/net/mac core/net core/net/mac/sicslowmac core/net/mac/contikimac core/net/llsec