# Sensinode CC2430 platform makefile
# Supported products: N100, N600, N601, N710, N711

# /dev supports defines for product models using the following format
# e.g. MODEL_N601. Run make TARGET=sensinode DEFINES=MODEL_N601 to 
# automatically configure the correct LED, button, UART etc. settings
# for that product model. If no model is defined, MODEL_N100 is chosen by default.
# Models settings are defined in /dev/models.h

# make sensinode.upload - Will use nano_programmer to upload file using D2xx Devboard
# make sensinode.serialdump - Will use the Contiki serialdump tool on the default UART

ifndef CONTIKI
  $(error CONTIKI not defined! You must specify where CONTIKI resides!)
endif
CFLAGS  += -DRIME_CONF_NO_POLITE_ANNOUCEMENTS
RIME_CONF_NO_POLITE_ANNOUCEMENTS = 1

# Define the default UART for tools and tool commands
DEFUART = /dev/ttyUSB0
PROG = $(CONTIKI)/tools/sensinode/nano_programmer/nano_programmer -d $(DEFUART)
SERIALDUMP = $(CONTIKI)/tools/sky/serialdump-linux -b115200 $(DEFUART)

CONTIKI_TARGET_DIRS = . dev
CONTIKI_TARGET_MAIN = ${addprefix $(OBJECTDIR)/,contiki-sensinode-main.o}

CONTIKI_TARGET_SOURCEFILES = contiki-sensinode-main.c \
                             leds.c leds-arch.c serial-line.c

CONTIKI_SOURCEFILES += $(CONTIKI_TARGET_SOURCEFILES)

.SUFFIXES:

%.upload: %.ihx
	$(PROG) -P $<

sensinode.serialdump:
	$(SERIALDUMP)

### Define the CPU directory
CONTIKI_CPU=$(CONTIKI)/cpu/cc2430
include $(CONTIKI)/cpu/cc2430/Makefile.cc2430

contiki-$(TARGET).a:# ${addprefix $(OBJECTDIR)/,symbols.o}