# Set this to the name of your sketch (without extension .pde) SKETCH=sketch EXE=arduino-example all: $(EXE) CONTIKI=../../.. # Contiki IPv6 configuration CONTIKI_WITH_IPV6 = 1 CFLAGS += -DPROJECT_CONF_H=\"project-conf.h\" LFLAGS += -lm PROJECT_SOURCEFILES += ${SKETCH}.cpp OneWire.cpp DallasTemperature.cpp # automatically build RESTful resources REST_RESOURCES_DIR = ./resources REST_RESOURCES_DIR_COMMON = ../resources-common REST_RESOURCES_FILES= $(notdir \ $(shell find $(REST_RESOURCES_DIR) -name '*.c') \ $(shell find $(REST_RESOURCES_DIR_COMMON) -name '*.c') \ ) PROJECTDIRS += $(REST_RESOURCES_DIR) $(REST_RESOURCES_DIR_COMMON) PROJECT_SOURCEFILES += $(REST_RESOURCES_FILES) # variable for Makefile.include ifneq ($(TARGET), minimal-net) CFLAGS += -DUIP_CONF_IPV6_RPL=1 else # minimal-net does not support RPL under Linux and is mostly used to test CoAP only ${info INFO: compiling without RPL} CFLAGS += -DUIP_CONF_IPV6_RPL=0 CFLAGS += -DHARD_CODED_ADDRESS=\"fdfd::10\" ${info INFO: compiling with large buffers} CFLAGS += -DUIP_CONF_BUFFER_SIZE=2048 CFLAGS += -DREST_MAX_CHUNK_SIZE=1024 CFLAGS += -DCOAP_MAX_HEADER_SIZE=640 endif # linker optimizations SMALL=1 # REST Engine shall use Erbium CoAP implementation APPS += er-coap APPS += rest-engine APPS += arduino include $(CONTIKI)/Makefile.include include $(CONTIKI)/apps/arduino/Makefile.include $(CONTIKI)/tools/tunslip6: $(CONTIKI)/tools/tunslip6.c (cd $(CONTIKI)/tools && $(MAKE) tunslip6) connect-router: $(CONTIKI)/tools/tunslip6 sudo $(CONTIKI)/tools/tunslip6 aaaa::1/64 connect-router-cooja: $(CONTIKI)/tools/tunslip6 sudo $(CONTIKI)/tools/tunslip6 -a 127.0.0.1 aaaa::1/64 connect-minimal: sudo ip address add fdfd::1/64 dev tap0 avr-size: $(EXE).$(TARGET).sz flash: $(EXE).$(TARGET).u $(EXE).$(TARGET).eu .PHONY: flash avr-size .PRECIOUS: $(EXE).$(TARGET).hex $(EXE).$(TARGET).eep