This example features a simple webserver running on top of the IPv6 contiki stack on Zolertia Z1 motes to provide sensor values, and with a RPL border router to bridge the sensor network to Internet. To test the example in COOJA under Linux ---------------------------------------- 1. Start COOJA and load the simulation "example-z1-websense.csc" > make TARGET=cooja example-z1-websense.csc 2. Connect to the COOJA simulation using tunslip6: > make connect-router-cooja 3. You should now be able to browse to the nodes using your web browser: Router: http://[aaaa::0212:7401:0001:0101]/ Node 2: http://[aaaa::0212:7402:0002:0202]/ To run the example on real nodes under Linux -------------------------------------------- 1. Program the nodes with the websense application > make TARGET=z1 z1-websense.upload 2. Disconnect the nodes and program one node with the RPL border router > (cd ../rpl-border-router && make TARGET=z1 border-router.upload) 3. Connect to the border router using tunslip6: > make connect-router 4. Reboot the router and note the router IP address 5. You should now be able to browse to your router node using your web browser: http://[]/. On this page you should see a list of all accessible nodes with their IP adresses.