CONTIKI_TARGET_DIRS = . dev apps net loader CONTIKI_CORE=contiki-main CONTIKI_TARGET_MAIN = ${CONTIKI_CORE}.o CONTIKI_TARGET_SOURCEFILES += contiki-main.c params.c node-id.c #Needed for slip CONTIKI_TARGET_SOURCEFILES += temperature-sensor.c adc.c led.c sensors.c slip_uart0.c slip.c leds-arch.c #Needed for Button CONTIKI_TARGET_SOURCEFILES += button-sensor.c #Needed for DHT11 humidity sensor CONTIKI_TARGET_SOURCEFILES += dht11.c #Needed for DS18S20 temperature sensor CONTIKI_TARGET_SOURCEFILES += ds1820.c #Needed for Battery test CONTIKI_TARGET_SOURCEFILES += battery-sensor.c #Needed for PIR CONTIKI_TARGET_SOURCEFILES += pir-sensor.c #Needed for OPTRIAC CONTIKI_TARGET_SOURCEFILES += optriac.c optriac-sensor.c CONTIKIAVR=$(CONTIKI)/cpu/avr #Needed for SERVO CONTIKI_TARGET_SOURCEFILES += servo.c servo-sensor.c #Needed for Timer4 Servo CONTIKI_TARGET_SOURCEFILES += t4-servo.c t4-servo-sensor.c CONTIKIBOARD=. BOOTLOADER_START = 0x1F000 CONTIKI_PLAT_DEFS = -DF_CPU=16000000UL -DAUTO_CRC_PADDING=2 MCU=atmega128rfa1 AVRDUDE_PROGRAMMER=jtag2 # For usb devices, you may either use PORT=usb, or (e.g. if you have more than one # programmer connected) you can use the following trick to find out the serial number: # # The example is for an JTAGICE mkII used to program an ATmega128: # avrdude -v -P usb:xxxx -c jtag2 -p atmega128 AVRDUDE_PORT=usb:00B000000D79 # Additional avrdude options # Verify off AVRDUDE_OPTIONS=-V #debug # CFLAGS += -save-temps # Bootloader bonsai # LDFLAGS += -save-temps LDFLAGS += -Wl,--defsym,bootloader_get_mac=0x0001f3a0 include $(CONTIKIAVR)/Makefile.avr include $(CONTIKIAVR)/radio/Makefile.radio