The CC2531 USB stick now identifies itself as a
'Texas Instruments CC2531 USB Dongle' and uses a
TI-assigmed VID:PID. The VID:PID is now configurable
in contiki- or project-conf.h
The sensinode platform does not support .upload and .serialdump
Their presence in the makefile has confused in the past confused
some users. This commit removes them
The commit also removes the $(OBJECTDIR)/%.rel: %.cS recipe which
is not used by either 8051 platform and is probably broken anyway,
since it has been unmaintained for years
- For the CC2538, simplify handling of USB_CDC_ACM_LINE_STATE
events. Ignore the Carrier Control (RTS) bit when receiving
a SET_CONTROL_LINE _STATE request, we are a full duplex device.
- Improve behaviour of the CC2531 USB stick when there is no
process on the host to read IN data. Basically, we adopt the
CC2538 approach and we only send data when a DTE is present
Setting UIP_CONF_IPV6 to zero from the make build command line is
something that seems like it should ensure that IPv6 is disabled, but in
fact it actually *enables* IPv6. This seems counter intuitive, so this
patch changes the behavior of the makefiles to handle this case
properly.
Copied this file to the platform directories and
changed it to use putstring(), puthex() etc so
that we can print addresses without linking in
printf
See Pull Request #20
This is based on a usb-test example by Philippe Retornaz. It has
been moved to platform and modified accordingly. With this in place:
- putchar() can work over USB. So we can use things like
printf, slip output
- USB input can be redirected to slip or serial input
The example itself is no longer needed in the source tree
See Pull Request #18
The P2 Interrupt is shared across many periferal (I2C, USB, GPIO).
This adds a generic interrupt handler on which the differents drivers
can register a handler.
See Pull Request #18
- Moved to their own file
(so we can later copy the entire thing over to cc2430)
- Renamed the functions
(for naming convention reasons)
- The entire thing can be enabled/disabled
- Added a couple more macros
- Hooked into main()
__bit variables must be located after the 0x20 address
This force the stack to start after 0x20, thus decrease
the stack size by a considerable amount.
