* Renamed packetbuf attribute PACKETBUF_ATTR_MAX_MAC_REXMIT to PACKETBUF_ATTR_MAX_MAC_TRANSMISSIONS where value 0 (attribute not set) means that default number of transmissions should be used.
* Low-power streaming. Experimental support for a low-power mode which
allows rapid exchange of packets with a 16% duty cycle. Does not
seem to function correctly yet though.
* Phase locking. When the phase of a neighbor has been detected, the
sender assumes that the neighbor will keeps it phase and does not
send more strobes than necessary to hit the receiver's channel
check - even if the receiver does not acknowledge the reception of
the strobes when it should have been awake. Instead, the sender
stops strobing and tries again at a later time.
main ideas are:
* Separates the Contiki low-layer network stack into four layers:
network (e.g. sicslowpan / rime), Medium Access Control MAC
(e.g. CSMA), Radio Duty Cycling RDC (e.g. ContikiMAC, X-MAC), and
radio (e.g. cc2420).
* Introduces a new way to configure the network stack. Four #defines
that specify what mechanism/protocol/driver to use at the four
layers: NETSTACK_CONF_NETWORK, NETSTACK_CONF_MAC, NETSTACK_CONF_RDC,
NETSTACK_CONF_RADIO.
* Adds a callback mechanism to inform the MAC and network layers about
the fate of a transmitted packet: if the packet was not possible to
transmit, the cause of the failure is reported, and if the packets
was successfully transmitted, the number of tries before it was
finally transmitted is reported.
* NULL-protocols at both the MAC and RDC layers: nullmac and nullrdc,
which can be used when MAC and RDC functionality is not needed.
* Extends the radio API with three new functions that enable more
efficient radio duty cycling protocols: channel check, pending
packet, and receiving packet.
* New initialization mechanism, which takes advantage of the NETSTACK
#defines.
of link-layer and MAC-layer mechanisms to achieve a very low power
consumption: during idle listening the radio is switched off between
99.2% and 99.6% of the time. One unicast transmission typically adds
between 0.07% and 1.2% additional radio time, depending on packet
size.
ContikiMAC uses the standard IEEE 802.15.4 message format and adds no
additional headers.
ContikiMAC is simple: it uses periodic two-shot channel sampling
during idle listening to keep the radio on-time down. Transmissions
are done with repeated transmissions until a link-layer ACK is
received.
of an rtimer for the periodic radio duty cycling. The benefit of this
implementation is that it leaves an rtimer free for user tasks. The
drawback is a slightly higher idle power consumption. This new version
is based on the current rtimer-based X-MAC.
channel_check_interval(). This function returns the interval by which
the duty cycling mechanism checks the radio channel for activity. It
is used by higher layer mechanisms to determine suitable timeouts for
retransmissions.
* the code is simplified, particularly the duty cycling logic
* old unused code has been removed
* Contiki X-MAC now listens before sending a strobe to avoid MAC-level
collisions
* broadcasts are sent directly, without strobes, reducing the power
consumption of receivers
* turn off radio for 1 ms between sending a strobe and expecting the
strobe ack
sicslowpan tags TCP packets with the PACKETBUF_ATTR_PACKET_TYPE_STREAM
flag, which makes the underlying power-saving MAC layer keep the radio
on for some time after transmitting the packet. This allows reply
packets to be processed directly, significantly increasing TCP latency
and throughput.
the packetbuf from packet attributes. Two framer modules are included,
one that creates 802.15.4 frame headers, and one that creates a
minimal "nullmac"-style header that only contains the link-local
addresses.
last were known to be awake. When sending a packet, a sender does not
start to send strobes until the neighbor is expected to be awake. This
reduces power consumption for senders and decreases the contention in
the network as there are less packets in the air. Additionally, the
ACK optimization was improved so that data/ack exchanges now are
more efficient.
sleep for OFF_TIME if the queue is empty.
restrict double packet lifetime timeouts to unicast packets.
stop ctimer in remove_queued_packet in case the function is not called
via the ctimer callback. it could overwrite a valid packet otherwise.
since libc rand() returns a signed int, there were frequently problems with
timer values wrapping. By reverting to random_rand(), we can provide a
random generator that returns an unsigned and the timer problems are solved.
architecture for the Rime stack for Contiki. The Chameleon
architecture separates the header processing from the Rime protocol
logic. Instead of having each protocol create its own part of the
packet header, protocols use packet attributes. Before sending a
packet, a special Chameleon header processing module creates a packet
header from the packet attributes. The same Chameleon module parses
incoming packets and creates packet attributes from the header.
The details are in our SenSys 2007 paper:
Adam Dunkels, Fredrik Osterlind, Zhitao He. An Adaptive Communication
Architecture for Wireless Sensor Networks. In Proceedings of the Fifth
ACM Conference on Networked Embedded Sensor Systems (SenSys 2007),
Sydney, Australia, November 2007.
http://www.sics.se/~adam/dunkels07adaptive.pdf
This is a rewrite of the code that was developed for the paper.
In order to support, some core modules are modified as follows:
core/sys/dsc.h
- If CTK_CONF_ICONS is diabled, the whole icon-related code is disabled.
- DSC_HEADER is changed to remove extra semicolon.
core/sys/process.h
- process_data_t is expressed by void* in signatures (known bug on sdcc).
core/sys/autostart.h
- autostart_processes is changed to remove extra semicolon.
core/sys/cc.h
- CC_CONF_ASSIGN_AGGREGATE is introduced.
- CC_CONF_INC_CAST_POINTER is introduced, a workaround of a kind
of sdcc bug for an increment.
core/net/hc.c
core/net/uip_arp.c
core/net/uaodv.c
- Aggregation assignments are changed to uip_ipaddr_copy.
core/net/psock.c
core/net/uipbuf.c
core/net/dhcpc.c
apps/shell/shell.c
core/ctk/vnc-server.c
core/ctk/vnc-out.c
- "register" keyword in a signature cannot be used in sdcc,
CC_REGISTER_ARG is used instead.
core/net/uip-over-mesh.c
- An extra semicolon is removed.
apps/dhcp/dhcp-dsc.c
apps/shell/shell-dsc.
apps/ftp/ftp-dsc.c
apps/process-list/process-list-dsc.c
apps/email/email-dsc.c
apps/webserver/webserver-dsc.c
apps/vnc/vnc-dsc.c
apps/vnc/vnc-viewer.h
apps/webbrowser/www-dsc.c
apps/about/about-dsc.c
apps/irc/irc-dsc.c
apps/telnet/telnet-dsc.c
apps/telnetd/telnetd-dsc.c
apps/netconf/netconf-dsc.c
apps/directory/directory-dsc.c
pps/calc/calc-dsc.c
- Modify an extern type to a real declaration, which is static
to prevent a compile error.
core/net/mac/xmac.c
- Variables cannot be defined in a head of block on sdcc.
core/ctk/ctk.h
core/ctk/ctk.c
apps/program-handler/program-handler.c
- If CTK_CONF_ICONS is diabled, the whole icon-related code is disabled.
Makefile.include
- Add a set of configuration for an assembler.
- $(CLEAN) variable is introduced for customized cleanup.
apps/process-list/process-list.c
- PROCESSLIST_CONF_HEIGHT is introduced to address smaller screen size.
core/lib/ctk-filedialog.c
- FILES_CONF_HEIGHT is introduced to address smaller screen size.
- "register" keyword in a signature cannot be used in sdcc,
CC_REGISTER_ARG is used instead.
apps/vnc/vnc-viewer.c
- A cast is added to prevent a compile error.
- "register" keyword in a signature cannot be used in sdcc,
CC_REGISTER_ARG is used instead.
apps/webbrowser/webclient.c
- CC_CONF_INC_CAST_POINTER is introduced, a workaround of a kind
of sdcc bug for an increment.
core/loader/elfloader.c
- A cast is added to prevent a compile error.
core/net/rime/rimeaddr.c
- An initialization is added to prevent a compile error.
core/net/rime/rudolph0.c
- NULL is changed to 0, because NULL causes a compile error.
core/net/rime/route-discovery.c
- Add an argument to match the definition of nf_callbacks.
cpu/z80/strcasecmp.h
cpu/z80/strcasecmp.c
cpu/z80/contiki-sdcc-conf.h
cpu/z80/mtarch.c
cpu/z80/mtarch.h
cpu/z80/Makefile.z80
- New files to make compilation availble on sdcc.
- Added support for multithreading.
