This patch adds an example program to print out information about the
configuration of the Intel Quark X1000 SoC Isolated Memory Regions
(IMRs), the Host System Management Mode Controls register, and the
Host Memory I/O Boundary register.
This patch adds an example for I2C callbacks that is very similar to
the i2c-LSM9DS0 example except that it uses a PWM device that is built
into the platform.
This patch revises the I2C and GPIO initialization code to always be
run during platform boot rather than within each process that requires
it.
This patch also revises the gpio-output example to use a pin that is
set as an output by the default pinmux configuration. Previously, it
used a pin that was set as an output by the pinmux configuration that
is in effect when the OS does not change the pinmux configuration.
This patch introduces an example application to demonstrate how to use
GPIO driver APIs to manipulate interrupt pins.
The application uses default galileo pinmux initialization and sets
the GPIO 5 (IO2) as output pin and GPIO 6 (IO3) as interrupt. It toggles
the output pin stat at every half second in order to emulate an interrupt.
This triggers an interrupt and the application callback is called.
This patch introduces an example application to demonstrate how to use
GPIO driver APIs to manipulate input pins.
The application uses default galileo pinmux initialization and sets the
GPIO 5 (IO2) as output pin and GPIO 6 (IO3) as input. It toggles the
output pin state at every half second and checks the value on input pin.
This patch adds an example application that shows how to use I2C driver
APIs to communicate with LSM9DS0 sensor. At every 5 seconds, the
application reads the "Who Am I" register from gyroscope sensor and
prints if the register value matches the expected value.
This patch introduces an example application to demonstrate how to use
GPIO driver APIs to manipulate output pins. The application sets the
GPIO 4 pin as output pin and toggles its state at every half second.
