* Renamed packetbuf attribute PACKETBUF_ATTR_MAX_MAC_REXMIT to PACKETBUF_ATTR_MAX_MAC_TRANSMISSIONS where value 0 (attribute not set) means that default number of transmissions should be used.
* Low-power streaming. Experimental support for a low-power mode which
allows rapid exchange of packets with a 16% duty cycle. Does not
seem to function correctly yet though.
* Phase locking. When the phase of a neighbor has been detected, the
sender assumes that the neighbor will keeps it phase and does not
send more strobes than necessary to hit the receiver's channel
check - even if the receiver does not acknowledge the reception of
the strobes when it should have been awake. Instead, the sender
stops strobing and tries again at a later time.
main ideas are:
* Separates the Contiki low-layer network stack into four layers:
network (e.g. sicslowpan / rime), Medium Access Control MAC
(e.g. CSMA), Radio Duty Cycling RDC (e.g. ContikiMAC, X-MAC), and
radio (e.g. cc2420).
* Introduces a new way to configure the network stack. Four #defines
that specify what mechanism/protocol/driver to use at the four
layers: NETSTACK_CONF_NETWORK, NETSTACK_CONF_MAC, NETSTACK_CONF_RDC,
NETSTACK_CONF_RADIO.
* Adds a callback mechanism to inform the MAC and network layers about
the fate of a transmitted packet: if the packet was not possible to
transmit, the cause of the failure is reported, and if the packets
was successfully transmitted, the number of tries before it was
finally transmitted is reported.
* NULL-protocols at both the MAC and RDC layers: nullmac and nullrdc,
which can be used when MAC and RDC functionality is not needed.
* Extends the radio API with three new functions that enable more
efficient radio duty cycling protocols: channel check, pending
packet, and receiving packet.
* New initialization mechanism, which takes advantage of the NETSTACK
#defines.
of link-layer and MAC-layer mechanisms to achieve a very low power
consumption: during idle listening the radio is switched off between
99.2% and 99.6% of the time. One unicast transmission typically adds
between 0.07% and 1.2% additional radio time, depending on packet
size.
ContikiMAC uses the standard IEEE 802.15.4 message format and adds no
additional headers.
ContikiMAC is simple: it uses periodic two-shot channel sampling
during idle listening to keep the radio on-time down. Transmissions
are done with repeated transmissions until a link-layer ACK is
received.
