Also get rid of genbackupisr hack: We can achieve the same thing with
avr-objcopy which doesn't need additional software.
We use the new bootloader setting for irq-save area of 0x800.
Compatible with old bootloader. Adds an additional section with a copy
of the interrupt vector table to the end of the image. This is needed by
the new bootloader and should be ok for the old bootloader.
Note that for this to work, everybody needs python installed with
the IntelHex python package. On Linux this can be achieved with
pip install IntelHex
update for MAC symbol counter. Basic functions for get/set-value
parameter setting added. SPI radios needs to be tested.
modified: cpu/avr/radio/rf230bb/atmega256rfr2_registermap.h
modified: cpu/avr/radio/rf230bb/rf230bb.c
The cc65 tool chain comes with V.24 drivers so it seems reasonable to use the existing Contiki SLIP driver to implement network access via SLIP as alternative to Ethernet.
Some notes:
- The Ethernet configuration was simplified in order to allow share it with SLIP.
- The Contiki SLIP driver presumes an interrupt driven serial receiver to write into the SLIP buffer. However the cc65 V.24 drivers aren't up to that. Therefore the main loops were extended to pull received data from the V.24 buffers and push it into the SLIP buffer.
- As far as I understand the serial sender is supposed to block until the data is sent. Therefore a loop calls the non-blocking V.24 driver until the data is sent.
On all platforms there's only one V.24 driver available. Therefore V.24 drivers are always loaded statically.
On the Apple][ the mouse driver is now loaded statically - independently from SLIP vs. Ethernet. After all there's only one mouse driver available. However there's a major benefit with SLIP: Here all drivers are loaded statically. Therefore the dynamic module loader isn't necessary at all. And without the loader the heap manager isn't necessary at all. This allows for a reduction in code size roughly compensating for the size of the SLIP buffer.
After all there's no momentum for a W5100-based Ethernet solution on the ATARI. So I revert to static linkage of the CS8900A driver as this improves program load times.
The CC13xx PROP mode TX power table can differ between boards as well as across frequency bands. This commit provides defaults for all bands and allows the board to override.
Harald Pichler
Ralf Schlatterbeck
Andreas Urke
Nicolas Tsiftes
George Oikonomou
Robert Olsson
Bernhard Hackl
Oliver Schmidt
Atis Elsts
Thanos Tsakiris
George Oikonomou