Updated control panel quickhelp
This commit is contained in:
parent
3286d62eca
commit
ef2338d2f3
|
@ -50,14 +50,17 @@ Currently, four event types are supported (see below). Note that the control pan
|
|||
|
||||
se.sics.cooja.plugins.SimControl = \
|
||||
<b>Control Panel</b>\
|
||||
<p>Use the control panel to start and stop the current simulation. \
|
||||
<p>Note that toggling simulation execution is also possible by the keyboard shortcut <i>Ctrl+S</i>. \
|
||||
<p><i>Step millisecond</i> executes all events within the next simulated millisecond. \
|
||||
<p>The execution speed can be controlled via the bottom slider. \
|
||||
If the slider value is non-zero, sleep events are scheduled in the simulation loop. \
|
||||
<p>By setting the slider to <i>Real time</i>, the execution speed is limited to at maximum real time. \
|
||||
The <i>Real time</i> slider value is to the right of <i>No simulation delay</i>: select the slider button and use to keyboard to navigate here. \
|
||||
<p><i>Run until</i> can be used to configure a time (in milliseconds) where the simulation will automatically pause.
|
||||
<p>The control panel controls the simulation. \
|
||||
<p><i>Start</i> starts the simulation. \
|
||||
<p><i>Pause</i> stops the simulation. \
|
||||
<p>The keyboard shortcut for starting and pausing the simulation is <i>Ctrl+S</i>. \
|
||||
<p><i>Step</i> runs the simulation for one millisecond. \
|
||||
<p><i>Reload</i> reloads and restarts the simulation. \
|
||||
<p>Writing simulation time in milliseconds in the <i>Stop at</i> field causes the simulation to pause at the given time. \
|
||||
<p>Simulation speed is controlled via the bottom slider. \
|
||||
If the slider value is zero, simulation runs at full speed. \
|
||||
<p>Setting the slider to <i>Real time</i>, simulation speed is capped to not run faster than real time. \
|
||||
The <i>Real time</i> slider value is to the right of <i>No simulation delay</i>: click on the slider button and press the right arrow key on the keyboard. \
|
||||
|
||||
se.sics.cooja.mspmote.plugins.MspCLI = \
|
||||
<b>MSPSim's Command Line Interface</b>\
|
||||
|
|
Loading…
Reference in a new issue