osd-contiki/examples/sensniff/zoul/target-conf.h

72 lines
3.2 KiB
C
Raw Permalink Normal View History

2016-07-24 05:09:46 +02:00
/*
* Copyright (c) 2016, George Oikonomou - http://www.spd.gr
* All rights reserved.
*
* Redistribution and use in source and binary forms, with or without
* modification, are permitted provided that the following conditions
* are met:
*
* 1. Redistributions of source code must retain the above copyright
* notice, this list of conditions and the following disclaimer.
* 2. Redistributions in binary form must reproduce the above copyright
* notice, this list of conditions and the following disclaimer in the
* documentation and/or other materials provided with the distribution.
* 3. Neither the name of the copyright holder nor the names of its
* contributors may be used to endorse or promote products derived
* from this software without specific prior written permission.
*
* THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS
* ``AS IS'' AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT
* LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS
* FOR A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE
* COPYRIGHT HOLDER OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT,
* INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES
* (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR
* SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION)
* HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT,
* STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE)
* ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED
* OF THE POSSIBILITY OF SUCH DAMAGE.
*/
/*---------------------------------------------------------------------------*/
#ifndef TARGET_CONF_H_
#define TARGET_CONF_H_
/*---------------------------------------------------------------------------*/
/* Set to 1 for a sub-ghz sniffer with the CC1200 */
#ifndef ZOUL_CONF_SUB_GHZ_SNIFFER
#define ZOUL_CONF_SUB_GHZ_SNIFFER 0
#endif
/*---------------------------------------------------------------------------*/
#if ZOUL_CONF_SUB_GHZ_SNIFFER
#define NETSTACK_CONF_RADIO cc1200_driver
/*
* You will need to configure the defines below to match the configuration of
* your sub-ghz network.
*/
#define CC1200_CONF_RF_CFG cc1200_802154g_863_870_fsk_50kbps
#define CC1200_CONF_USE_GPIO2 0
#define CC1200_CONF_USE_RX_WATCHDOG 0
#define CC1200_CONF_802154G 0
#define CC1200_CONF_802154G_CRC16 0
#define CC1200_CONF_802154G_WHITENING 0
#define ANTENNA_SW_SELECT_DEF_CONF ANTENNA_SW_SELECT_SUBGHZ
#endif
/*---------------------------------------------------------------------------*/
/*
* Selection of Sensniff I/O Interface.
* Define CC2538_IO_CONF_USB as 0 to use UART0 as sensniff's interface.
*/
#define CC2538_IO_CONF_USB 0
/*---------------------------------------------------------------------------*/
#if CC2538_IO_CONF_USB
#define USB_SERIAL_CONF_ENABLE 1
#else
#define UART0_CONF_BAUD_RATE 460800
#endif
/*---------------------------------------------------------------------------*/
#define SENSNIFF_IO_DRIVER_H "pool/cc2538-io.h"
/*---------------------------------------------------------------------------*/
#endif /* TARGET_CONF_H_ */
/*---------------------------------------------------------------------------*/