osd-contiki/examples/osd/sensniff/cc2538dk/target-conf.h

57 lines
2.7 KiB
C
Raw Permalink Normal View History

2017-10-10 11:31:12 +02:00
/*
* Copyright (c) 2016, George Oikonomou - http://www.spd.gr
* All rights reserved.
*
* Redistribution and use in source and binary forms, with or without
* modification, are permitted provided that the following conditions
* are met:
*
* 1. Redistributions of source code must retain the above copyright
* notice, this list of conditions and the following disclaimer.
* 2. Redistributions in binary form must reproduce the above copyright
* notice, this list of conditions and the following disclaimer in the
* documentation and/or other materials provided with the distribution.
* 3. Neither the name of the copyright holder nor the names of its
* contributors may be used to endorse or promote products derived
* from this software without specific prior written permission.
*
* THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS
* ``AS IS'' AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT
* LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS
* FOR A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE
* COPYRIGHT HOLDER OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT,
* INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES
* (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR
* SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION)
* HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT,
* STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE)
* ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED
* OF THE POSSIBILITY OF SUCH DAMAGE.
*/
/*---------------------------------------------------------------------------*/
#ifndef TARGET_CONF_H_
#define TARGET_CONF_H_
/*---------------------------------------------------------------------------*/
/*
* Selection of Sensniff I/O Interface.
* Define CC2538_IO_CONF_USB as 0 to use UART as sensniff's interface.
* This will default to using UART0, unless you also define
* CC2538_IO_CONF_USE_UART_1 as 1.
*
* Don't forget to also set a correct baud rate (460800 or higher) by defining
* the corresponding UART0_CONF_BAUD_RATE or UART1_CONF_BAUD_RATE
*/
#define CC2538_IO_CONF_USB 1
#define CC2538_IO_CONF_USE_UART1 0
/*---------------------------------------------------------------------------*/
#if CC2538_IO_CONF_USB
#define USB_SERIAL_CONF_ENABLE 1
#else
#define UART0_CONF_BAUD_RATE 460800
#endif
/*---------------------------------------------------------------------------*/
#define SENSNIFF_IO_DRIVER_H "pool/cc2538-io.h"
/*---------------------------------------------------------------------------*/
#endif /* TARGET_CONF_H_ */
/*---------------------------------------------------------------------------*/